This is a mini-scale model of a suspension bridge I made in July of 2008. I remember that it was a bit hard to construct in LDD, mainly because of getting the angle of the hinges on the "cable" just right.
This is just a close up of the cable connections on the bridge - I had used the "cheese slope" brick to try and make it appear that the cable was attached to the bridge.
Feel free to download the LDD file attached, if you want to analyze this even further. Comments and constructive criticism are welcome as always.
Not bad pal, LDD is more difficult then actually building when it comes to design. I speak of my Pony Truss and the difficulties I had when in design mode, Very nice, I just may borrow it when I re-design my train set.