MOCpages : Share your LEGO® creations
LEGO models my own creation MOCpages toys shop The Phantom T.I.E. FighterTIE craft
Welcome to the world's greatest LEGO fan community!
Explore cool creations, share your own, and have lots of fun together.  ~  It's all free!
The Phantom T.I.E. Fighter
The Modified V38 Assault Fighter
About this creation

The TIE Phantom was a modified version of the V38 assault fighter, leading some to refer to the starfighters by this designation, as well as the more common "Phantom TIE." Design-wise, it was a member of the TIE series, which dominated the Empire's starfighter fleet during the Galactic Civil War. However, it was distinctive among the series in that its solar array wings were attached directly to the fuselage, perpendicular to the hull, rather than to pylons extending from it. Like in the TIE/D Defender, the wings were equally spaced around the hull, with one located directly above the cockpit, and two below and to either side.[2]



Whereas most TIE series starfighters in use at the time had a spherical cockpit section, the TIE Phantom's cockpit was elongated,[2] and reminiscent of some Corellian Engineering Corporation freighters, including the YT-1300 light freighter, and the later Sienar Scimitar assault bomber.[8] The section behind the cockpit was roughly triangular, with the wings mounted to the tips, and contained the ship's twin ion engines. With no landing gear, the fighters had to be supported when aboard ship to keep the lower wings off the surface. A launch mechanism would grip the fighter by the upper wing and maneuver it into position when departing.[2]
A TIE Phantom with its entry hatch open.



Entry into the cockpit was possible through an elevator hatch on the bottom of the fuselage. The fighter was designed for a crew of two: one piloting the vessel, while the other acted as a gunner. The crew's positions in the cockpit were staggered, with the gunner sitting forward and to the right, while the pilot took the rear left console. Both positions had a computer display, along with the controls required to operate the ship. Unlike most fighters in the TIE series, the TIE Phantom featured life support systems, allowing the crew to operate it without the bulky helmet and breathing equipment required by most TIE pilots. The crew did, however, wear a headset with a microphone and headphones to assist communication in-flight.[2]



The TIE Phantom was armed with two laser cannons mounted to the body under the cockpit, which could be set to fire-linked.[2] Three more laser cannons were mounted on the tips of its three wings, and all five could be fired simultaneously to maximize the effectiveness of a shot.[7] The vessel was designed to be tougher than the ubiquitous TIE/ln starfighter, and also possessed deflector shields for defense—a feature not present in standard TIE models. Another unusual feature for a TIE Fighter was the hyperdrive, which enabled the TIE Phantom to travel between star systems.[5]
A TIE Phantom fires its laser cannons.



However, the TIE Phantom's most unusual feature was its cloaking device. The device utilized stygium crystals[6] to give the fighters an ability unheard of in ships their size in recent decades—the ability to appear effectively invisible to the naked eye, while at the same time evading sensors and scanners aboard other vessels. When a TIE Phantom was cloaked, other vessels could, at best, detect only an unusual sensor anomaly and were unable to get a firm reading. Even other TIE Phantoms were unable to penetrate the cloaking shield. To take full advantage of the cloaking device, the vessels had a built-in mechanism that allowed the pilot to fire the fighter's lasers at any time, with the cloaking device being automatically shut off and turned back on after every volley. This allowed them to remain unseen until the moment of firing, thus getting the jump on their enemy, and to be virtually invisible the vast majority of the time, even during a dogfight.[2]



The technology in the TIE Phantom was considered a potential threat to the Empire, should it have ever fallen into enemy hands. To prevent this scenario, the designers fitted each fighter with a self-destruct mechanism that could be activated remotely, so that should one ever be captured, nobody would be able to replicate its technology.[2]







Comments

 I like it 
  August 27, 2011
I have only seen a handful of these and this is among the best so far. I haven't dabbled with this TIE variant yet but you have left me inspired.
 I like it 
  June 4, 2011
This is really cool, inspirational. Ive been wanting to build one for a while. 5/5
 
By michael D
Add to my favorite builders

2
people like this. See who.

1,386 visitors
2 comments
Added December 21, 2009
 


LEGO models my own creation MOCpages toys shop The Phantom T.I.E. FighterTIE craft


You Your home page | LEGO creations | Favorite builders
Activity Activity | Comments | Creations
Explore Explore | Recent | Groups
MOCpages is an unofficial, fan-created website. LEGO® and the brick configuration are property of The LEGO Group, which does not sponsor, own, or endorse this site.
©2002-2018 Sean Kenney Design Inc | Privacy policy | Terms of use