A miniland-scale stromtrooper I designed for a friend.
About this creation
A miniland-ish scale Stormtrooper that I created for and upcoming dio by fellow a href="http://cactusbrick.org/"> member Dave Shaddix. Unfortunately according to Dave, he's a little short for a stormtrooper, so I'll be making a bigger version of him soon.
Ignore the blue pin in back. It'll be replaced by a 1x1 brick with a stud out in front once I snag a few. Kinda sloppy on my part. :/
Quoting Louis K.
Nice miniland figure! You've definitely inspired me to make some. I'm only wondering how you attached the head to the body, since the head is studs down and the body studs up.
Good question. If you look at a shot of the back part of the trooper, you'll notice about half way down 2 1x4 tiled plates touching one another. This, along with the bricks above and below the upside down tiled plate allow the head/midsection of the back to stick together via friction- and it's completely sturdy. Could there be another possible solution?- probably, but this was the best one I found when creating the fig like this. I really wanted the top of the helmet to use that rounded tile connector.