Hello MOCers and people of the internet. I am back with a cool little tutorial on how to make a turtle mech. I was surfing the web when I found a picture of this little guy. I decided I wanted to make one. While there was no tutorial on the internet, I made my own. Take that internet! Anyways, here you go.
--On to the MOC---
For this mech, you will need the following pieces:
First, take the octagon connector and stick the four black pieces shown.
Next, take the connector and put it on the bottom of the previous piece.
Add the four white heads to the four black pieces (Yes, they are printed).
Take the four grey studs and stick them on the bottom of the head.
Turn it right-side up and stack two studs on top of one another and stick it into the center of the octagon connector. The light grey has to be on the bottom, and the tan can be substituted for any color stud.
Take the disc and put it on top of the stud.
Then take this piece...
and stick it there. Mind the grey piece on the top.
Take the connector, and stick a orange stud on the front hole. colors can varry.
Then take the 1x1 flat square plate and stick it on top of the stud. Make sure the connector and this piece are the same color.
The head is done!
Now take this hole(the one im pointing to)...
An stick it on top of the black piece in front.
You will need these pieces for the cannons:
Take the pistol-like piece and stick the red stud in the front. Colors can varry.
Take the cyllinders and stick it on top of the stud.
Then take the grey pieces and stick them inside the cyllinder.
Take the cannons and put them on either side of the grey piece.
Thats it! I hop you've enjoyed this tutorial. Until my next MOC. See ya!