The Batpod (version 2).: A LEGO® creation by Failed Frog ! : MOCpages.com

The Batpod (version 2).

Rated 5 out of 5 Change your rating

Zoom in

This is my Batpod version 2, after a flash of inspiration and a look at other Batpods (thank you Velociraptor on Cuusoo). I decided to strip my old one down for parts.

About this creation

The rear side view shows how I used some artistic flair in this model because after I built and attached the gun assembly (which I like best of all) on the front, the back of The Batpod looked bear and thin looking.

This image shows The Batpod in its entirety, its overall length is not huge roughly 12 studs long, longer than I would like but neither the less all 12 studs are needed.

This shot gives you a size comparison of how long The Batpod is next to a Minifigure, it is 12 studs long but that is 12 studs put to good use

With this picture I have stood Batman next to The Batpod as a size comparison to show you how tall The Batpod stands, again a little taller than I would like but the wheels are the same as the ones I used on the front of The Tumbler.

The next few pictures show what Batman looks like whilst on The Batpod, this one is a front view of him on it, although he is almost laying flat on The Batpod the Minifig is hold the steering grips lifting the torso slightly.

Here we have different view for Batman riding The Batpod. You can see from this that the front forks are slightly angled down to give the model a slight lift in the middle.

This one is another one of Batman on The Batpod, form this angle you can clearly see that the front wheel is connected one side just like the actual Batpod, which I feel is an important part of the actual Batpod.

This last shot shows both of Batman’s vehicles (which I know isn’t possible) although The Tumbler is in the background it is longer that The Batpod.

If I get enough requests, I will put on a parts list and building instructions.

Please rate and comment :-)

Thank you for looking :-)

Comments

Add a comment

I made it

Failed Frog !

September 21, 2013

Quoting Giulio Manuelli The shape is perfect! Can the wheels rotate like in the film? If you look my bat-pod i have done it..

Thanks for the comment, sadly due to the angle of the front wheel, a rotating piece isn't possible, if you check out my building instructions for the bat pod there is an updated version for the cannons.