A republic troop carrier from Star Wars. Specifically from the microseries.
About this creation
The CR-20 troop carrier briefly appears in the microseries when Anakin follows Asajj Ventress to Yavin 4. Along with him comes a squad of clone troopers in a CR-20 troop carrier.
I tried to balance size with accuracy when I created it, so my CR-20 doesn't have the largest space, but it isn't too wide or long in comparison to the real thing.
There are several inaccuracies, but my CR-20 TC is one of the most visually accurate on MocPages.
This CR-20 has room for a maximum of 13 clone troopers in its cargo bay, 2 in its control center, and 1 in its cockpit. It also has a 74-Z speeder bike in its lower compartment. The speeder bike can come out either end.
There is one double turbolaser cannon on each wing, and its landing gear retracts to match the ship. (note: I couldn't make the landing gear retract like in the microseries. Instead, its hinges are external)
One thing I knew I had to do was to make the cargo bay accessible. I allowed the ship to completely split apart through the middle so that you can easily place troops into it.
Here, the landing gear folds up
This is the storage compartment for the 74-Z speeder bike
and here is the speeder bike (it's longer than it looks! I was surprised that I could only fit this into the compartment)
This is the boarding ramp to the cargo bay, where most of the storing and transporting is done
Here's the command station, located in the upper portion of the ship, right in the middle where the dark red line is
The top comes off to reveal the cargo bay
And without any clones
Here's a picture of the turbolaser
So there you have it. It didn't take too long to build, just a day. I had to use up the whole day though, and I didn't eat until I was starving. I was really excited to finish this project.