The lower section of the model was built entirely using clear 1x2 bricks. It was very challenging to glue them without the glue showing!
To keep the area see-through, I did not use a lot of lower supports, and as a result, a lot of warping and damage occurred when the model was shipped. After the event, the logo was sent back to me for repair; I am currently re-building the model for its permanent installation at LPL's headquarters.
Here I am with the logo, about to be shipped. It was built in 9 seperate "stackable" sections, each glued together so that they could be easily assembled onsite. Unfortunetly, the poorly-reinforced lower clear sections were damaged en route, so the model became very difficult to assemble onsite.
I am reinforcing it with metal piping, a wood baseboard, and fusing all 9 sections together. It will be re-shipped as one piece in a large crate.