Part two of my personally created LEGOŽ pieces. Please comment! And feel free to leave more ideas and suggestions! I'd be happy to design them for you!
About this creation
This is an addition to the already exsisting upright holder piece. This is a replacement to the 1x2 rocker boxes. It is better because it can swivel 180° rather than the rocker's 90°. It's also easier to work with because it's only 1x1 instead of 1x2.
Here's the bottom. Sorry, my CAD skills are not great enough yet to know how to tilt the hinge.
This is a piece I'm sure everyone's wanted at one point. It's a reverser plate! MegablocksŽ has the same basic plate but it's 2x2 and I think it's time LEGOŽ built one.
Same on the other side of course. This piece would eliminate those complicated reversing techniques that people have come up with like the pin and rubber band technique.
This ones simple. It's just a shorter version of the rod pieces. Only two studs long instead of four. This could have a ton of uses that the bigger size could not. Also this means you would have to cut one!